| C-1: Chain: Verify it is latched in place. Chain is not broken or missing links. |
|
| T-1: Two Hand Control: No cracks or missing pieces. Test that both hands are required to operate machine. |
|
| F-1: Foot Control: Cover is secured over the pedal. |
|
| E-1: Emergency Stop Button: Red color, no cracks or missing pieces. Must be working – Push when machine is not in operation and then try to start machine. |
|
| H-1: Hard Guard: Attached to machine. All fasteners in place. Guard is secure and does not have sharp edges. |
|
| I-1: Interlocked Guard: When machine is not in operation, test that machine will not start when interlock guard is open. |
|
| A-1: Adjustable Guard: Adjust the guard to the height/length of the material to be cut or to cover the extra open section(s) of the machine. |
|
| P-1: Perimeter Guard: In good condition and secured to floor. No missing bolts. No sharp edges. |
|
| L-1: Light Curtain: When machine is not in operation, test that machine will not start when the light curtain is blocked. |
|
| EP-1: Emergency Pull Cord: Red color. Must be working – Push/pull when machine is not in operation and then try to start machine. |
|
| SM-1: Safety Mat: When machine is not in operation, step on mat and test that machine will not start until it is reset. |
|
| S-1: Shield: No cracks or missing pieces and is secured to the machine. Must be put into place prior to using the machine. |
|
| IDB-1: Interlocked Die Blocks: Test interlock plugs: turn off motor, making sure flywheel is stopped. Disconnect interlock plug, verify motor will not start. |
|
| GFS-ST: Soft Touch Guards factory installed by equipment manufacturer. Use test tool to verify guards are functioning |
|
| SG: Safety Gauge: Use to gauge Tongue Guard at 1/4″ or less and the Work Rest at 1/8″ or less |
|
| GFS-1: Factory Installed By Equipment Manufacturer: Automatic Interlocked Closing Doors |
|
| PC: Plastic Curtain: Plastic Curtain covering open area, make sure all flaps of curtain are there and in good condition |
|
